What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
14.06.2025 04:56
These devices are installed between the “hot” and “neutral” and protective ground.
Upvotes:
but I think this circuit , shows a few more pieces.
He then describes Rainy Season and Lightning.
The MOV will conduct when the voltage exceeds 50% of line voltage.
a photo is worth a thousand words.
Which Shakespeare words have completely changed meaning in modern English?
I post the exact comment here.
So, the voltage could go up to 500 volts, and the fuse will not open up.
It seems Mohan does not understand the difference between a comment and an Answer.
How would you spank me if I had been sent home from a school camp because of my poor behavior?
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
This is where this question deviates from being a 'generic' question, and becomes more specific.
At one ohm, the resistor has a maximum of 1 watt power.
When was you wife swapping fantasy started?
What is lightning?
He then describes the function of a fuse.
One is “what exactly is in a ‘surge protector’ ? ”
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
2024–10–16 [ OO OLAOYE OYEBODE ]
An AC voltage/ current source, and an ac inductive load.
This device then solves the entire problem.
eight
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
Do polyphenols in mushrooms fight cancer or cause side effects?
Now when you have a certain ac resistance, then a current flows in a loop.
For this case there are devices called Metal oxide varistors (MOV).
There are three different concepts here that are getting confused.
What does success really mean to you? Is it about happiness, money, or something else?
In schematic diagrams this is the symbol for a fuse:
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
This is the picture of an electronic coil of wire wound around a core of magnetic material.
Edit 2024–10.
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
First Sentence:
How can I control my daily masturbating habit?
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
Can the fuse protect the electronic devices from lightning instead of a surge protector.
Because the load is inductive, the current lags the voltage.(by a bit).
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
This one hit behind the barn.
Barnstars:
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
[image of Common-mode choke]
Here is a simplified AC power diagram.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
but this device (an Inductor) … impedes the rapid changes in the current.
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
so, what happens?
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
(Dc diagram shown, AC is similar).
One
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
[old diagram got deleted by accident]
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
At least they know the answer if they wanted it.
nine
the problem then depends on "how fast does the fuse operate?".
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
what exactly is a ‘surge’ protector?
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
The other is “what does a “fuse” do?”
This is 'the assistant's answer'
But… the neutral is now “floating” because of the 1 ohm resistance.
A fuse is a non-resetable over current circuit protector.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
2024–10–10[John johnson John Johnson ]
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
But it can get overloaded, and no longer works.
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
The bolt then partially travels down the line to your home.
What does a fuse do?
He then asserts :
A circuit breaker is similar, but is resettable.
2024–10–14 [Omar Gharbi Omar Gharbi ]
These are simplified answers to the original question, and does not change anything I wrote above.
There are two important concepts here.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
It also is a device that limits the change in current flow.
This is where the MOV conducts again, and dissipated the energy.
The third is lightning and “how it gets conducted into a home.”